Featured Discussion
Phil Johnston
I have had a lot of recent debate about the most effective/optimal torch oil to use in our FCC. Some of the older operators insist that using feed is good. I am trying to convince them that cycle oil is better. Any supporting thoughts out there?
May 07, 2012 10:06 pm
-
Chris Steves: I think the best choice is unit dependent. Since torch oil should only be used during startup,... More
May 08, 2012 05:57 am
-
Stuart Daphne: I agree with Chris that it will vary somewhat by specific unit, but i would tend to think that if... More
May 08, 2012 07:53 pm
-
Phil Johnston: Stuart, those were my thoughts exactly!! Chris - thank you for your thoughts as well.
May 13, 2012 08:08 pm
-
Richard Rhead: Only use feed when you are starting up because there won't be any HCO available. But then switch... More
May 18, 2012 09:36 pm
-
Tim Swaty: Feed is the most expensive oil to use as touch oil. You need BTU's an fuel oil, if available is... More
May 24, 2012 07:28 pm
